Is There Custom Towed Vehicle Wiring Available For A 2011 Chevy Cruze LS
Published 12/28/2023
Products Featured in This Question
Question:
Do you have a Custom Tail Light Wiring Kit for Towed Vehicles for a 2011 Chevy Cruze LS
asked by: Nicholas J
Expert Reply:
There unfortunately are no custom tail light wire harnesses available for a 2011 Chevy Cruze so you'll need to go with a splice-in diode kit like the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit # RM-15267 instead. Since your Cruze has separate lighting this kit will cause your brake lights to function as both brake and turn signal lights. A wiring converter # 118158 and two additional diodes # RM-792 will be needed if you want to retain separate turn and brake signals.
Product Page this Question was Asked From
Hopkins Custom Tail Light Wiring Kit for Towed Vehicles
- Flat Tow Wiring Harness
- Plugs into Vehicle Wiring
- Wiring Harness
- Custom Fit
- 4 Flat
- Hopkins
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Q&A: Recommended Flat Tow Setup for a Motorhome w/ Air Brakes Pulling a 2016 Jeep Wrangler Unlimited
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can Demco Base Plate Be Used With NSA Ready Brute Tow Bar On 2025 Ford Maverick?
- Q&A: Can I Use Bullseye Wireless Monitor Without Pairing The Curt RVi Shadow 2 Brake System?
- Article: Trailer Wiring Diagrams
- Article: Best Vehicles to Flat Tow Behind an RV
- Q&A: Which is Better Roadmaster or Blue Ox Tow Bar
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Must-Have Flat Towing Components
- Q&A: Parts Needed For Flat Towing a 2017 Jeep Wrangler Unlimited Rubicon
- Q&A: Choosing Between the Brake Buddy Select 3 and the Blue Ox Patriot Supplemental Braking System
- Q&A: Looking For Complete Flat Tow Setup For 2013 Jeep Wrangler With D-Ring Bumper
- Article: Roadmaster Vehicle Specific Base Plates