Replacement End Cap for TracRac Ladder Rack Load Bars

Question

Question:

i have track rack. i need black caps 4 at the top left and right of ladder rails.my rack isaround 5 years old.

asked by: Pat S

0

Expert Reply:

It sounds like you are looking for replacement end caps for the ends of the bars on your TracRac ladder rack. For a single replacement use # TA01-27023. It will fit TracRac G2, T-Rac G2, and TracONE truck bed ladder racks.

expert reply by: Michael H

0

Answer 1

The Replacement Double T-Slot Cross Bar #TA8523447003 comes with just the bar. If you need end caps for these bars you can use the Replacement End Caps #TA01-27023. I've also listed some potential hardware replacement options for a TracRac…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hey Rick, thanks for the pictures. Sounds like a tough situation but congrats on your new truck. The base rails can be cut on the Thule TracRac SR Sliding Truck Bed Ladder Rack item #TH43003XT-501. This will allow you to install the rack on your 2026…

view full answer...

Answer 5

Hey Ron, congratulations on the new trailer! I have a Jay Feather myself and love it. You're definitely off to a great start with a weight distribution hitch, it will make a world of difference towing that trailer with your F-150. The Weigh Safe…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Hey Dave, the install harness part #3063-P does fit to the green connector that is under your seat in your 2025 Mercedes Benz Sprinter 4500 and would work great with the P3 part #90195 which is widely considered to be the best controller around. I…

view full answer...

Answer 11

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Replacement End Cap for TracRac Ladder Rack Load Bars

Product Page this Question was Asked From

Continue Researching