Adding a 7-Way Trailer Connector to a 2008 Toyota Highlander Hybrid with Existing 4-Way Connector

Published 04/10/2014

Products Featured in This Question

Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires

(3470)

$118.67

Question:

would this part be able to fit onto a 2008 highlander hybrid with a 4 flat item number 118449? if so how would it be done?

asked by: Joshua C

Expert Reply:

You could install the Pollak 7-Pole and 4-Pole Trailer Connector Sockets w/ Mounting Bracket and Wiring # HM40975-11998 on your 2008 Toyota Highlander with the 4-Way, # 118449 already installed.

You would have to cut off the 4-Way plug on the 118449. Then the white wires would connect to each other, the 4-Way brown wire would connect to the 7-Way brown wire. The 4-Way yellow wire would connect to the 7-Way red wire. And the 4-Way green wire would connect to the 7-Way green wire.

On the 7-Way harness, the blue wire is for electric trailer brakes, black is for 12 volt power, and yellow is for reverse lights. To make all of these fully functional you would need additional wire and parts.

Instead of this 7-Way I recommend the 4 and 7-Way installation kit # ETBC7. It comes with a 7-Way that you will just plug your existing 4-Way into. It also comes with the extra wire and accessories to wire up the other functions.

If you need a brake controller I recommend the P2, # 90885. This is one of our most popular controllers because it is easy to set up and use and its reliable. I have included some links that show and explain the ETBC7 installation.

expert reply by: Michael H