Troubleshooting Pop and Lock Tailgate Lock Install on a 2010 Ford F150 Where All Locks Stop Working
Updated 04/07/2014 | Published 04/06/2014
Question:
When installing all wires were located with test light and confirmed. When pop lock is connected nothing works not even the actual truck locks. When unhook truck locks resume working. Please let me know what to do. Thanks.
asked by: Robert H
0
Expert Reply:
I spoke to my contact at Pop and Lock and he informed me that you are most likely using the incorrect wiring. He advised me to have you double check that you are using the correct circuits to wire in this # PAL8250.
I attached an install video for you to check out.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Pop & Lock Custom Tailgate Lock - Power - Black
- Tailgate Locks
- Lock Only
- Power Lock
- Keyed Alike
- Vehicle Specific
- Black
- Pop and Lock
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Looking For Electric Brakes And Hub/Drums For Lippert 3,500 lb Axle
- Q&A: What are the Correct Bearings, Races, and Seals for 4,400 Pound Axle?
- Q&A: Installing The BakFlip F1 Hard Tonneau Cover On 2012 Honda Ridgeline
- Q&A: Does The BAKBox 2 and BAKFlip Cover Allow Access To Trunk In Honda Ridgeline
- Q&A: Will the BAKFlip G2 Hard Tonneau Cover # BAK26601 Limit Trunk Access on a 2014 Honda Ridgeline
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Selection of Timbren Rear Axle Suspension Kit for 2006 Ford F250 Crew Cab Short Bed 4WD
- Q&A: Replacement Brake Shoes For Al-KO 10" X 2-1/4" Electric Brake Drums On a 2002 Forest River Flagstaff
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices