Does Hellwig EZ-550 Install In Front or Behind Rear Axle on 2023 Toyota Tacoma

Question

Question:

Where exactly do you mount or attach helper springs to exst truck leaf springs? In front or behind truck axle?

asked by: Daryl B

0

Expert Reply:

The Hellwig EZ-550 # HE72FR installs above the leaf spring behind the axle on your 2023 Toyota Tacoma. See the picture below.

expert reply by: Robin H

0

Hellwig EZ-550 Installation
(click to enlarge)

Answer 1

Bearings and seals are generally measured in inches. It is best to use a digital caliper, like #PTW80157, and measure out to 3 decimal places to find the most precise figure. I've attached an image that shows how to measure and identify them. As…

view full answer...

Answer 2

Yes, it does. The Hellwig EZ-550 Helper Springs item #HE72FR installs directly above your 2018 Toyota Tacoma's leaf springs. You will not need to modify anything.

view full answer...

Answer 3

Hello Dave. The Hellwig Above Axle Helper Springs will definitely help add support and stop the vehicle from sagging. The Hellwig EZ-550 Helper Springs - Above Axle #HE72FR is what I recommend for your 1996 Toyota Tacoma. While these will help with…

view full answer...

Answer 4

Since you have a 2 inch lift in the rear of your 2005 Toyota Tacoma you would also need the spacer kit part #AL52420 with the Air Lift Load Lifter 5000 kit part #AL49DQ that fits your truck.

view full answer...

Answer 5

Hey Tony, the Hellwig helper springs part #HE72FR that you referenced are a confirmed fit for your 2020 Toyota Tacoma and will also help provide additional support to the suspension to level it when towing like you asked about. Is there a reason you…

view full answer...

Answer 6

We can definitely get you replacement bearing kits for your Dico 40511 brake drum, but I was unable to find out what it originally came with, unfortunately. So with that being said, you will need to either measure the inside diameters of both the…

view full answer...

Answer 7

Hello Jeff, thanks for getting in touch. The Hellwig EZ-550 Helper Springs #HE72FR will indeed fit your 2020 Toyota Tacoma 4x4 4 door long bed. There will not be any modifications required. You basically just jack up the truck by the frame then…

view full answer...

Answer 8

The height of the SumoSpring Solo Custom Helper Springs #SSR-612-47 is 4-1/2". Since you have a lift on your 2023 Toyota Tacoma you will need to measure to see if they will fit or not. There should be 1/2" - 1" gap once installed for…

view full answer...

Answer 9

Those are very good questions and let's start with the capacities of both systems. The SumoSprings Solo Custom Helper Springs #SSR-612-40 has a 500 lb capacity and SumoSprings #SSR-612-47 has a 1,000 lb capacity, which means that is the highest…

view full answer...

Answer 10

No, you can not and the Hellwig EZ-550 Helper Springs item #HE72FR mount on top of the leaf springs. However, they do not fit a 2012 Nissan Xtrerra. The only option we have for a leaf spring system for your Nissan are the RoadActive Suspension Custom…

view full answer...

Answer 11

The Timbren Active Off-Road Bumpstops - Rear Suspension - 3,600 lbs #TABSTRFK have bump stops and mounts that are 5-1/2 inches tall overall and u-bolts that are 8-1/4 inches long and 3-3/4 inches on center. I've attached a photo to assist. These…

view full answer...

Answer 12

Good question, and the difference between the Ride-Rite air bags for your 2021 Toyota Tacoma is actually the fit, as the right one will depend on if your leaf springs are above your axle or below your axle: - Axle Located Below Leaf Spring Pack:…

view full answer...

Does Hellwig EZ-550 Install In Front or Behind Rear Axle on 2023 Toyota Tacoma

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching