Replacement Hardware For The TorkLift SuperHitch Original Trailer Hitch Receiver # TLF1002

Question

Question:

Curious if it is possible to just purchase the bolts for Item # TLF1002. Thank you

asked by: Jim B

0

Expert Reply:

We currently only offer the bolts of the TorkLift SuperHitch Original Trailer Hitch Receiver # TLF1002 as a kit with the washers, nuts, etc. with part # TLM8003-F1002.

expert reply by: Kevin C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 5

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 6

Hey Ross, the B and W Turnoverball #BWGNRK1067 wasn't designed to fit under a flat bed so there isn't an alternate set of measurements I can recommend. Are you sure it would clear under the flat bed? Normally we have to recommend the…

view full answer...

Answer 7

The Curt T-connector vehicle wiring harness for factory tow package 7 way and 4 pole flat connectors #C55774 is a confirmed replacement and fit for your Ford F-150 Lariat. It connects quickly and easily with no cutting or splicing of wires. The…

view full answer...

Answer 8

Yes. If you don't need the weight distribution bars attached to carry the trailer to storage, you can absolutely use just the WD hitch head and ball to tow the trailer. It will work just like a ball mount.

view full answer...

Answer 9

The towing capacity of the 2003 Chevrolet Avalanche 1500 with 5.3L V8 and 4.10 rear axle is 8100-lbs. For a 7600-lb GVWR travel trailer the resulting 500-lb safety margin is adequate/low-ish. With a trailer that weighs substantially more than the tow…

view full answer...

Replacement Hardware For The TorkLift SuperHitch Original Trailer Hitch Receiver # TLF1002

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching