Installation Instructions for the SureCall Fusion2Go 3.0

Updated 10/02/2023 | Published 09/29/2023

Question:

I have a 2022 Solitude 345 with a residential refrigerator. What is the best way to run the SureCall Fusion2GOcable from the roof antenna to the booster? Can I use the factory installed cables in my Winegard 360+ dome? Many Thanks in advance!

asked by: Steve R

Expert Reply:

No, you can't use the factory cables used with your Winegard 360+ with the SureCall Fusion2Go 3.0 RV Cell Phone Signal Booster # SC43MR because the cabling is a bit different.

To install the SureCall Fusion2Go 3.0, you'll need to make sure that you have at least a 12" radius clear from any obstructions to mount the outside antenna. Once that spot is identified, you can go ahead and install the antenna to the roof of your RV following the provided instructions.

You'll then need to mount the booster within a cabinet or on a side panel close to a power source. The antenna should be aimed vertically, and the location you select should generally be in the center of where signal is needed. Also, avoid excessive heat, direct sunlight, or moisture, and make sure the unit gets proper ventilation.

There is no set way to route the cables, so I'd recommend just picking a route that is pretty direct, and then fill the hole with some weather resistant silicone to prevent leaks.

expert reply by: Bryce D