Does The Furrion Oven FSRD22LASS Have Elevation Limitations
Updated 09/05/2023 | Published 09/03/2023 >
Question:
Does the furrion oven have elevation limitations? We recently went camping at an elevation of approximately 5000 feet. The oven did not want to work. It would light and stay lit for about 2 minutes then shut off. Is this normal? Thanks for any advise.
asked by: Matt M
Expert Reply:
The Furrion Ovens like the # FSRD22LASS do not have any elevation limitations. It is certainly not normal for it to run fine, then shut off after two minutes.
I recommend starting your oven and letting it run. When you shuts off check to see if you can still smell gas. If you can still smell gas, It is likely that something is wrong with the internal regulator. If you do not smell gas then something is likely activating the auto shut off. This could be due to a lack of pressure which would also point back to a problem with the regulator.
Product Page this Question was Asked From
Furrion Propane RV Cooktop - 3 Burners - 24-7/16" Wide - Stainless Steel
- RV Stoves and Ovens
- Cooktop
- Propane
- 12V
- 3 Burners
- Stainless Steel
- Furrion
more information >
Continue Researching
- Q&A: What are the Dimensions of the Replacement M6 Channel Nut for the Rhino-Rack Pioneer 6 Platform?
- Q&A: Dimensions of Furrion Stoves FGH4ZSASS and FGH3Z25BL
- Q&A: Does The New Dylux Tankless Water Heater For RVs Run On 120V Electric Or Just Propane?
- Q&A: Wiring Diagram For A Dometic WH6GA Water Heater
- Q&A: Will Coleman Release a Heat Pump Version of the Mach Everest RV Air Conditioner?
- Q&A: Does Dometic FreshJet 3 part # DMC69ZR Require Additional Control Board
- Q&A: Shortest Retracted Height Trailer Jack
- Article: How to Raise Your Travel Trailer Height
- Article: How Does an RV Water Pump Work?
- Article: How Your RV Water System Works: A Complete Newbie's Guide
- Article: Can You Flat Tow a Jeep Compass?
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Install E-Track in 3 Easy Steps
- Article: Brake Controller Installation: Starting from Scratch

