What Size are the Mounting Holes for LED Mini Trailer License Plate Light # LPL31CB
Updated 03/24/2014 | Published 03/20/2014 >
Question:
what is the screw size or hole in this part? How big a hole behind this part is needed to clear the two wires coming out the back side?
asked by: Stever
Expert Reply:
I went out to the warehouse and pulled LED Mini Trailer License Plate Light # LPL31CB to take some measurements for you. This light does include some screws to mount it. The screw holes are approximately 3/16 inches in diameter. I made a video for you showing the dimensions for you.
The wires coming out of the back are coming out of a couple of round nubs. The overall dimensions of the nubs (the hole size to cut if needed) would need to be 1/2 inch across by 1/4 inch tall.
Product Page this Question was Asked From
Optronics Mini LED Trailer License Plate Light w/ Chrome Housing - 2 Diodes - Rectangle - Clear Lens
- Trailer Lights
- License Plate Lights
- License Plate
- Rectangle
- Surface Mount
- Non-Submersible Lights
- LED Light
- 2-3/4L x 1-3/8W Inch
- White
- Optronics
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Q&A: Replacement 24-1/4" Long 2-Leaf Slipper Spring for a 1,000 lbs Axle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Ribbed Rubber Mats for Floor of Horse Trailer
- Q&A: Rubber Mat Needed for a 7 foot x 20 foot Gooseneck Featherlite Stock Trailer
- Q&A: Availability of Single Wire Plug for Optronics Clearance Light MCL67ARB
- Q&A: Parts Needed to Add Brake Controller to 2026 Ford Transit T350
- Q&A: How Much Should It Cost To Completely Rewire a Trailer
- Q&A: Replacement Door Latch for 3/4" Thick Door on Featherlite Trailer
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How Much Solar Power Do I Need For My RV?
- Article: How to Measure for Trailer Hitch Drop

