Trailer Wiring Recommendation for a 2003 Pontiac Vibe Towing a Yakima Rack and Roll Trailer
Updated 03/21/2014 | Published 03/20/2014
Products Featured in This Question
Question:
I am looking at the purchase of a hitch and Yakima Rack and Roll trailer for use with my 2003 Pontiac Vibe GT. I wanted to make sure that this is the proper harness to use with the trailer as it specifies about 9 amps on the Yakima website. Thank you,
asked by: Todd P
Expert Reply:
The Curt Wiring Harness part # 55057 that you referenced is the correct wiring harness for your 2003 Pontiac Vibe. This unit should do very well to power and operate the taillights of a Yakima Rack and Roll trailer like part # Y08107.
The trailer will pull about 9 amps total, whereas the # 55057 is good for 6 amps per circuit. Which is more than enough.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Visible
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Trailer Wiring Options for a 2005 Pontiac Vibe GT
- Q&A: Recommended Trailer Hitch for a 2009 Toyota Matrix XRS
- Q&A: Recommended Trailer Hitch And Small Trailer For A 2003 Toyota Matrix XR Hauling A Motorcycle
- Q&A: Can a 2009 Pontiac Vibe Safely Tow a 1,500 Pound Boat Trailer
- Q&A: Availability of a 2 Trailer Hitch for a 2004 Toyota Matrix to Carry a Bike Rack
- Q&A: How to Tell the Difference Between a 4-Bolt and a 10-Bolt 5th Wheel Hitch Mounting Rail
- Article: Roadmaster Tow Bar Feature Descriptions
- Q&A: Recommended Flat Towing Components For A 2024 Chevy Trax
- Article: Performance Chips and Modules
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure