Does Roller of CE Smith Keel Roller assembly part # CE32005G Need to be Replaced with Bolt and Nut
Published 08/17/2023
Question:
One of the reviews claims the main axle end cap clamps came off the center pin and that a bolt and nylock should be used instead. Interested in your response. Thank you.
asked by: Mark M
1
Helpful Expert Reply:
In general the CE Smith Keel Roller assembly part # CE32005G works really well as-is and does not require replacing the roller with a bolt and nylock washer. That could potentially work but I would not recommend that as a requirement at all.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
CE Smith Keel Roller Assembly for 2" Wide Trailer Tongues - Galvanized Steel and Black Rubber
- Boat Trailer Parts
- Rollers
- Keel Roller
- 11-1/2 Inch Tall
- Rubber
- 4 Inch Long
- CE Smith
more information >
Continue Researching
- Q&A: Looking for 9" Wide Rollers and Brackets for a Holsclaw Boat Trailer
- Q&A: Recommended Winch and Mounting Bracket for a Malone Microsport Trailer
- Q&A: Will 12 inch Keel Roller Help Load Boat on Trailer in River
- Q&A: How Does a Keel Roller Fit on 5/8 Inch Shaft
- Q&A: Recommended 5.30X12 Tire and Wheel with High Speed Rating
- Q&A: Can You Flat Tow A 2023 Subaru Crosstrek With A Manual Transmission
- Q&A: Recommended Highest Capacity Roller Bunks
- Article: Boat Trailer Guides: Which are the Best?
- Article: How to Attach a Cargo Carrier to a Roof Rack
- Article: Hitch Mounted Cargo Carrier Information
- Article: Rooftop Cargo Carriers
- Article: Slipper Spring Trailer Suspension System Review