Troubleshooting a Roadmaster InvisiBrake Supplemental Braking System Compressor Not Working
Question:
Installed InvisiBrake RM-8700 on 2020 Ford Escape Hybrid full time electric brakes and system not working. Pulled brake-away switch and nothing happens. No compressor sound or pressure being shown. Brake is not being applied. Have turned pressure down in case it was all the way up. Verified there is 12 volts at power plug. Have not connected to the MH yet so it has not seen normal brake signal yet. What is my next step in troubleshooting the issue.
asked by: Ed W
Expert Reply:
Pulling the breakaway pin is not the correct way to test the Roadmaster InvisiBrake Supplemental Braking System # RM-8700 in your 2020 Ford Escape Hybrid. You will need to have everything installed and hooked up on both the vehicle and motorhome side. You will also need to have the motorhome running when you perform the test, which is done by pressing the brake pedal.
I have also included the installation instructions, the test process starts on page 16. If you perform all of this and are getting the same results, I have included some compressor troubleshooting below.
There are two fuses wired to the air compressor circuit. One 20 amp fuse on the power wire of the battery, and a 10 amp fuse connected on the blue wire that runs from the ignition switch to the air compressor.
Inspect these fuses and any poor or loose wiring connections. Try using a jumper wire 12-volt source to connect to the compressor to see if it operates. If the compressor works, then the issue is along the wiring. If the compressor does not work, then there may be an issue with the unit itself.
Product Page this Question was Asked From
Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Tow Bar Braking Systems
- Brake Systems
- Pre-Set System
- One Time Set-Up
- Fixed System
- Power Assist Brake Compatible
- Air Brakes
- Hydraulic Brakes
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Shop: Second Vehicle Kit for Roadmaster InvisiBrake Flat Tow Brake System
- Q&A: Removing Roadmaster Invisibrake Supplemental Braking From One Vehicle to Install on Another
- Q&A: Vacuum Line and Tee Fitting Availability for Roadmaster Invisibrake
- Q&A: What Is Needed to Install a Roadmaster InvisiBrake Supplemental Braking System in Second Car
- Q&A: Installation Of The Second Vehicle Kit for Roadmaster InvisiBrake Braking System
- Q&A: How Does Air Line Behind Roadmaster Invisi-Brake Release from Unit
- Q&A: Removing Roadmaster InvisiBrake System from Vehicle
- Q&A: Parts Needed to Switch Roadmaster InvisiBrake Supplemental Braking System to Different Vehicle
- Search Results: invisibrake 8700
- Shop: Demco Stay-IN-Play Duo Flat Tow Brake System for RVs w/ Hydraulic Brakes - Proportional
- Shop: Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Search Results: pulley mounting bracket
- Search Results: wiring kit
- Shop: Replacement Air Cylinder for Roadmaster BrakeMaster Flat Tow Brake System
- Shop: Pulley Mounting Bracket for Roadmaster InvisiBrake Flat Tow Brake System
- Shop: Roadmaster Brake-Lite Relay Kit for Towed Vehicles
- Search Results: base plates
- Video: Blue Ox Patriot Portable Braking System Installation - 2022 Ford F-150
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Search Results: tow bar
- Video: Roadmaster Tow Bar Wiring - Splices into Vehicle Wiring - RM-15267 Review
- Article: Must-Have Flat Towing Components
- Search Results: base plate
- Video: Review of Blue Ox Tow Bar Braking Systems - Patriot Portable Braking System - BLU37TR
- Video: Roadmaster InvisiBrake Braking System Installation - 2021 Jeep Wrangler
- Article: Roadmaster Vehicle Specific Base Plates
- Search Results: rm~88400
- Video: Blue Ox Patriot Radio Frequency Portable Braking System Review