Can The LC370794 Be Cut Down To Fit A 19" Deep Compartment?
Published 07/27/2023 >
Products Featured in This Question
Question:
My compartment is 19 inches deep can the rails be cut and do you need the trim kit
asked by: Terry T
Expert Reply:
The rails on the Kwikee tray assembly # LC370794 cannot be cut down to size. While the trim kit is not required it is certainly recommended to keep gear from sliding off when you extend the tray.
A 19" deep compartment does not give us a whole lot of room to work with. I do carry one generator slide # MR69RR that is 15-3/4" deep and 23-1/8" wide. This is the only one I have that would be shallow enough to fit in a 19" deep compartment. I do have the # MR89RR which is 19-1/4" deep if you think you could make that work. These are generator trays so they can hold a good bit of weight- up to 250 lbs.
Product Page this Question was Asked From
Rail Kit for Kwikee RV Cargo Slide Tray Assembly - 22" Long - 400 lbs
- RV Cargo Slides
- Cargo
- No Floor
- Adjustable
- 1 Way
- 22 Inch Long
- 400 lbs
- Kwikee
more information >
Continue Researching
- Q&A: How Much Floor Clearance Is There With the Kwikee Heavy Duty Tray Assembly Kit LC370794
- Q&A: Recommended MORryde Sliding Tray For Dometic CFX3 95DZ
- Q&A: What are the Interior Dimensions of the MORryde Refrigerator Tray # MR69UR?
- Q&A: Best Slide-Out Tray Options for Camper Van Storage 32" Deep x 48" Wide
- Q&A: Does The Use of a Reducer Affect the Tongue and/or Trailer Weight Capacity?
- Q&A: Will Upgrading My Trailer Hitch Increase The Towing Capacity Of My 2024 Ford F-250?
- Q&A: Dimensions Of The MORryde Generator Tray MR99RR
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Measure for Trailer Hitch Drop
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Determining Trailer Tongue Weight
- Article: Where to Position the Trailer Axle?

