What Size Screws Are Needed for the Replacement Lippert Solera Awning Head?
Updated 07/24/2023 | Published 07/21/2023
Question:
What size screw is needed for a Lippert motor cover screw?
asked by: Edward C
0
Expert Reply:
The correct screws for the Replacement Idler Head for Solera Power RV Awnings with Built-in Speakers # LC342150, are #6-15 UNF x 1/2”.
expert reply by:
Bryce D
0
Product Page this Question was Asked From
Replacement Idler Head for Solera Power RV Awnings with Built-in Speakers - Plain Style - Black
- Accessories and Parts
- RV Awning
- Head Parts
- Speaker Head
- Head Assembly - Power
- Solera Replacement
- Drive Head
- Black
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Looking for Replacement RV Awning Head Covers
- Q&A: What is the Diameter of the Solera Awning Rollbar Tube
- Q&A: Correct Replacement for Solera RV Awning V000251669
- Q&A: What Lippert Lead Leg and follow Leg do I Need for My Gen 2 Level Up Hydraulic Leveling System?
- Q&A: Replacement Plain Drive Head Front and Rear Covers for a Solera 2000 Series 12V Power Awning
- Q&A: How Do I Know If My Solera Awning Is Plain Or Regal Style?
- Q&A: Replacement Head Pin For Solera Power Awnings
- Article: How to Install an RV Awning From Scratch
- Article: How to Replace a Rubber RV Roof
- Article: Trailer Wiring Diagrams
- Article: Hitch Mounted Cargo Carrier Information
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers