How to Wire Curt Converter to Filter Out Turn Signal on Center Light
Updated 06/25/2023 | Published 06/23/2023 >
Products Featured in This Question
Question:
I texted with robin H once about about filtering out the turn signals from a center tail light. I want the center light to be tail and brake but not blink. I got the Kurt convertor from yall but have a couple of further questions. 1 which of the two green and yellow wires am I hooking into the tail light wiring? right or left, or both? 2 can I make all these connections up front at the hitch. I have the pigtail with the junction box built on. Make them there?
asked by: Wayne E
Expert Reply:
You can splice in the converter wherever you want. If it is at the front you will just have to run extra wire back to the rear for that center light. You can use # DW02508-1 if you want to keep it consistent with red. You don't want to filter out the stop for your regular tail lights so the wires running to them now need to stay the way they are.
I went ahead and attached a wiring diagram for the # C56196 to the original answer and down below. If you aren't sure what the functions are on the trailer wiring to hook up, I would test them with a circuit tester like # PTW2993. You said this is a vintage trailer and sometimes wiring colors don't match or there are a lot of wires on the trailer. Whatever is carrying the combined signal needs to get filtered through the converter and then you will run the red stop wire back to the center light.
Product Page this Question was Asked From
Curt 2-to-3 Tail Light Converter for Towed Vehicles w/ Incandescent Tail Lights
- Flat Tow Wiring Harness
- Splices into Vehicle Wiring
- Tail Light Converter
- Universal Fit
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Solution for Replacement Breakaway for Discontinued Hopkins Brake Buddy
- Q&A: Recommendations on Flat Towing a 2017 Honda Fit with a Manual Transmission.
- Q&A: What Fuses Need to be Pulled to Flat Tow 2017 Honda Fit
- Q&A: How to Get Separate Turn Signals and Brake Lights to Work on a Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Q&A: Full Flat Tow Setup For 2023 Ford F-150 and 2026 Jayco Greyhawk
- Q&A: Which is Better Roadmaster or Blue Ox Tow Bar
- Q&A: Is There An Advantage To Choosing A Tow Bar With Longer Arms
- Article: We Used 34 RV Tow Bars, and These are the Best for Flat Towing
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Flat Towing Package for 2008-2011 Honda CR-V


