Is Drilling Required for Installation of Pop & Lock Fuel Door with BOLT Lock for Jeep Wrangler
Updated 06/20/2023 | Published 06/17/2023
Question:
You stated in another question about the pop and lock pl3000 that drilling is required for installation, but I just watched a video where no drilling was required? You just line up the correct plastic pins in original body hole ? Which is correct ?
asked by: Chuck
0
Expert Reply:
Drilling is not required for the installation of the Pop & Lock Fuel Door with BOLT Lock for Jeep Wrangler # PL3000. The housing fits in place of what you currently have using the locator pin and presses into place. The screws are only used to attach the door to the housing.
expert reply by:
Robin H
0
Product Page this Question was Asked From
Pop & Lock Fuel Door with BOLT Lock for Jeep Wrangler JK - Black
- Vehicle Locks
- Fuel Door Lock
- Vehicle Specific
- Black
- Pop and Lock
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How To Find The Correct Replacement Keys For An Enclosed Trailer Access Door
- Q&A: Is There a Weight Capacity for TorkLift Locking FastGun Turnbuckles
- Q&A: Replacement Jack for Atwood 81911 Trailer Coupler
- Q&A: Recommended Bike Rack and Hitch Receiver for 2018 Jeep JL Wrangler with E-Bikes
- Q&A: Does Draw Tite Hitch # DT78MR Fit 2021 Jeep Wrangler Willys
- Q&A: Cross Bars And Bike Rack Recommendation For Pace Edwards Tonneau Cover With Ultragroove Rails
- Q&A: Correct MORryde X-Factor Crossmember for CRE Equalizer