Parts Needed To Install Tekonsha Prodigy P2 On a 2009 Porsche Cayenne With Tow Package

Question

Question:

Hello - I have a 2009 Porsche Cayenne w/towing package that I would like to tow with. From my prior tow vehicle I also have a Tekonsha Prodigy P2. I understand the Cayenne needs a wiring adapter to fit the factory plug. Do you sell these adapters? I also read about a possible need for an additional relay with my Prodigy controller - is this needed? Thanks.

asked by: Roger D

0

Expert Reply:

I have linked the Technical Bulletin below for installing a Tekonsha Prodigy P2 # 90885 on your 2009 Porsche Cayenne with the factory tow package. You will need the Plug-In Wiring Adapter # TK22FR along with the Relay # BL63VR to wire the connector as seen in the bulletin by splicing into the red wire on the adapter.

expert reply by: Bud M

0

Answer 1

The factory plug for installing the Prodigy P2 #90885 on your 2015 Volkswagen Touareg TDI should be located under the vehicle's dash on the driver's side close to the door. You will need to acquire the following from your Volkswagen dealer to…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Parts Needed To Install Tekonsha Prodigy P2 On a 2009 Porsche Cayenne With Tow Package

Featured Help Information

Miscellaneous Media

Continue Researching