Dimensions and Recommended Mounting Hardware for the LED Mini Trailer License Plate Light
Published 02/13/2014 >
Question:
Could I get the recommended mounting hardware, hole size, and thickness at the mounting holes for this product?
asked by: Jake M
Helpful Expert Reply:
The LED Mini Trailer License Plate Light # LPL31CB comes with installation screws, but if needed you could install it with other hardware. You might find that a self-tapping screw would work better if you plan on installing this to a metal surface.
The distance on center between the mounting holes is 2 inches. The diameter of the holes is 3/16 of an inch. And the thickness at the mounting holes is an 1/8 of an inch.
Product Page this Question was Asked From
Optronics Mini LED Trailer License Plate Light w/ Chrome Housing - 2 Diodes - Rectangle - Clear Lens
- Trailer Lights
- License Plate Lights
- License Plate
- Rectangle
- Surface Mount
- Non-Submersible Lights
- LED Light
- 2-3/4L x 1-3/8W Inch
- White
- Optronics
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Q&A: Replacement 24-1/4" Long 2-Leaf Slipper Spring for a 1,000 lbs Axle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Rubber Mat Needed for a 7 foot x 20 foot Gooseneck Featherlite Stock Trailer
- Q&A: Ribbed Rubber Mats for Floor of Horse Trailer
- Q&A: Availability of Single Wire Plug for Optronics Clearance Light MCL67ARB
- Q&A: Parts Needed to Add Brake Controller to 2026 Ford Transit T350
- Q&A: How Much Should It Cost To Completely Rewire a Trailer
- Q&A: Replacement Door Latch for 3/4" Thick Door on Featherlite Trailer
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How Much Solar Power Do I Need For My RV?
- Article: How to Measure for Trailer Hitch Drop

