Inner Leg Height and Wall Thickness etrailer Jack # TJD-8000S
Updated 03/20/2023 | Published 03/18/2023
Question:
How long is the actual leg square tube from the foot to the end of the tube not top hole? And what is the wall thickness of the leg tube?
asked by: Harold
1
Helpful Expert Reply:
The overall height of the drop leg of the etrailer jack # TJD-8000S is 17-3/4 inches. The wall thickness is right at 1/8 of an inch.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Square Direct Weld Trailer Jack w/ Footplate - Drop Leg - Sidewind - 15-1/8" Lift - 7,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Sidewind Jack
- 6001 - 7000 lbs
- Manual Jack
- 28-7/8 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Recommended Replacement for Vision LED PTC-BAK-01 Breakaway Kit
- Q&A: What is the Difference Between SuperCrew and SuperCab Ford Truck
- Q&A: Recommended Rear Stabilizer Jacks for a 14,000 lbs Trailer
- Q&A: Replacement Jack Recommendation for Replacing Shelby 6108SW
- Q&A: Solution for Towing Trailer With Air Brakes
- Q&A: Replacement Brake Assemblies and Hub/Drum for Airstream with Nev-R-Lube Hub/Drums
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Maintenance Schedule
- Article: Trailer Jacks
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers