What Light Hole Dimensions Does Westin Fey Bumper Have
Published 03/14/2023
Question:
I would like to use my Ford OEM license plate lights in the installation on my 1976 Ford F250. What size diameter are the holes in the bumper and how long are the rectangular slots for the Westin license lights? I assume the rectangular slots are symmetrical around the centerline of the holes ? I want to make sure the OD of my OEM lights will hide the slots, as the OEM bumper has only round holes for the lights. Thanks for your time.
asked by: Tom R
Expert Reply:
I attached a picture that has dimensions of the lights that normally fit into the light slots of the Westin Fey Bumper # 21000-92230. The width of the slot is right at 1.38 inches.
(click to enlarge)
Product Page this Question was Asked From
Westin Fey Diamondstep Rear Bumper with Custom Installation Kit - Chrome Plated Steel
- Bumper
- Step Bumper
- Rear Bumper
- Steel
- Chrome
- Westin
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What Is The Widest Step Bumper You Sell
- Q&A: Length Of Westin Fey Diamondstep Rear Bumpers
- Q&A: Looking For Rear Step Bumper For 1969 Chevy C10
- Q&A: Correct Westin Bumper And Installation Kit For 1997 Ford F-350
- Q&A: What Does the 5 and the J Indicate on a 15x5J Trailer Wheel and ST205/75D15
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: How Long is the Westin Fey Diamondstep Rear Bumper 21000-92230
- Q&A: Which Westin Hardware Kit for Installing Fey Bumper on 1992 Ford F-150
- Article: Types of Bumpers
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit