Locating Replacement Leaf Springs For a Atchison Welding 10 Bale Hay Trailer
Updated 02/20/2023 | Published 02/17/2023
Question:
Hi my leaf spring is 28.5 inches long it has 6 plates on it do you have anything like that its for a Atchison welding hay trailer 10 bale
asked by: Angela
Expert Reply:
Based on the information I could for a 10 bale Atchison Welding trailer I only see that it uses 7,000lb axles with slipper springs. The 5-Leaf Slipper Spring w/ Hook End # e74SR is currently the closest spring we have but it no near long enough at 26-5/8" when not compressed. At most it would span 28-1/6" when completely flat. If you have different weight capacity axles and can provide additional information on the springs I may be able to see if we have a different weight rating which may fit your trailer.
Product Page this Question was Asked From
5-Leaf Slipper Spring w/ Hook End for 7,000-lb Trailer Axles - 26-5/8" Long
- Trailer Leaf Springs
- Slipper Springs
- 9/16 Inch Eye
- Nylon Bushings
- 7000 lbs
- 2 Inch Wide
- 5 Leaf
- 26-5/8 Inch Long
- Standard Grade
- etrailer
more information >
Continue Researching
- Q&A: Slipper Spring Hanger Positioning for 7,000 lb Tandem Axle
- Q&A: Replacement for a Dexter 072-032-00 Slipper Spring
- Q&A: Looking For Replacement Slipper Springs For My 7k Dexter Axle
- Q&A: Are There Exact Hanger Spacings to Use with Terran Slipper Spring Hanger Kit # TX85VJ
- Q&A: Can I Switch From 5-Leaf Slipper Springs to 7-Leaf Springs?
- Q&A: Trailer Slipper Spring to Replace Dexter 072-032-00 Spring
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Wiring Diagrams
- Q&A: What Ohms Should Trailer Brake Magnets Be?
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Raise Your Travel Trailer Height
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)