Dimensions of the Weld-On Zinc Spring Latch
Updated 10/23/2009 | Published 10/22/2009
Question:
Wat is the overall length of pin and size of square part
asked by: Richard H
0
Expert Reply:
The overall length of the pin in the Weld-On Zinc Spring Latch, item # SL58W, is 3-5/8 inches. The Square part is 1-1/2 inches wide by 1-1/4 inches tall by 2 inches long. There are cutouts in the 2 inch long sides that accept the roll pin to hold the latch open when the handle is twisted.
expert reply by:
Robert G
0
Product Page this Question was Asked From
Continue Researching
- Article: What Do I Need To Tow A Trailer?
- Q&A: Replacement Brakes, Hubs and Drums For Dexter 10K General Duty Prior To July 2009 With 9-44 Drums
- Q&A: Replacement Brake Assemblies for Dexter Trailer Hub 9-44
- Q&A: How to Install the Factory Ford Puck System on a 2007 Ford F-350
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Drop Leg that Can be Used with etrailer A-Frame Jack
- Q&A: Where Is Factory Brake Controller Plug Located On 2010 Ford Explorer Sport Trac
- Q&A: What is Weight Rating for the CE Smith Safety Chains # CES82QR
- Q&A: Availaiblity of White Half Moon Trailer Vent
- Article: Trailer Hitch Installation Tips
- Article: Trailer Lighting Requirements
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How to Tell the Weight Rating of a Trailer Axle