Replacement Roof Vent Lid for 1998 Chinook
Published 01/20/2023
Question:
I need to replace the vent cover on my 1998 Chinook. The old cover blew off so I dont have that as an example. the hinge on the base is a Cinch type that is not continuous photo attached. Looks like a 4 gap pin type? What is the correct replacement model? Thanks in Advance for your help.
asked by: Mike P
0
Expert Reply:
Thanks for the picture of your roof vent. Based on that you have the pre-2008 Elixir roof vent and would need thelid part # CAM40155.
expert reply by:
Jameson C
0
Elixir Roof Vent Lid
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Camco Replacement Lid for Ventline and Elixir RV Roof Vents - Polypropylene - White
- RV Vents and Fans
- Replacement Lid
- Roof Vent
- Plastic
- White
- Camco
more information >
Continue Researching
- Q&A: Can Dylux Tankless RV Water Heater Be Used In Winter? Does It Have Freeze Protection?
- Q&A: Front and Back Replacement Covers for a Lippert Solera 2000 Awning
- Q&A: Recommended Replacement for Atwood OD5001CW Direct Water Heater
- Q&A: Replacement RV Vent Cover Lid with UV Protection
- Q&A: Replacement Vent Cover with Track on Side for Raising or Lowering Lid
- Q&A: Replacement 7 Inch Wheels for a Fulton F2 Twin-Track Jack
- Q&A: Draw-Tite 06623-099 Wt. Dist Hitch w/ Sway Control Chain Hangers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Replace an RV Roof Vent Cover
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Troubleshoot Your RV Air Conditioner
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Launch a Boat from a Trailer (And Load it Back Up)