How Does DeeZee Tailgate Assist for Chevy Silverado # DZ43100 Install on Truck Body
Updated 01/03/2014 | Published 12/28/2013
Question:
Is there any special receiving latch that has to be connected to truck body?
asked by: Ralph
Expert Reply:
The DeeZee Tailgate Assist for Chevy Silverado # DZ43100 installs without drilling on the drivers-side of your truck using the included hardware. Installation consists of removing two OEM bolts, one near the hinge and one where the cable attaches, with a 13mm socket and installing the included post stud and shock.
You do not need to modify the vehicle (again, no drilling and no cutting) and all required parts for complete installation are included in the kit.
Product Page this Question was Asked From
DeeZee Tailgate Assist Custom Tailgate-Lowering System for Classic Chevy Silverado / GMC Sierra
- Lift Supports
- Vehicle
- Tailgate Assist
- DeeZee
more information >
Continue Researching
- Q&A: How Can I Get Trailer Lights to Flash when Disconnected from Truck
- Q&A: Installing Side Trailer Lights to Blink with Corresponding Turn Signal
- Q&A: Tailgate Assist that Fits 2016 Ford F-350 Super Duty
- Q&A: Recommended 12v Refrigerator Replacement For A Norcold 1210 RV Refrigerator
- Q&A: Comparing the Curt Spectrum, Tekonsha Voyager iD, and Redarc Tow-Pro Elite Brake Controllers
- Q&A: What is Difference Between Curt, etrailer, and TowSmart Hitch for 2026 Hyundai Santa Fe
- Q&A: Does Truck Bed Remove to Install HappiJac Tie Down Anchors on 2005 GMC Sierra 3500