Replacement Motor for Lippert Power Gear Electric Leveling Jack System

Question

Question:

I am needing the motor only. The end cap of the motor that mounts the electric brake is broken and that’s all I need. If you can get me any other alternative to this that would be great. Thanks

asked by: Stephen

0

Expert Reply:

If you are needing the motor that comes with the Replacement Motor for Lippert Power Gear Electric Leveling Jack System # LC89CJ, this is the only way that we have that available.

If I have misunderstood what you are needing, please let me know and I would be happy to assist you further.

expert reply by: Scott S

0

Answer 1

The only difference between the left #LC386198 and right #LC89CJ motors for the Lippert Power Gear is going to be the brake orientation; Other than that they are going to be the same motor. As far as your situation goes, If you have the extra money…

view full answer...

Answer 2

The correct replacement gear motor that replaces the Power Gear 1510000006 on your 2006 Fleetwood Fista is the Replacement PowerGear RV Above Floor Slide-Out Motor #LC368417. The Replacement Gear Motor #LC368193 you were looking at will not work…

view full answer...

Answer 3

The Power Gear Motor 1010000155 has direct replacements of Replacement Motor for Lippert Power Gear Electric Leveling Jack System part #LC386198 or part #LC89CJ. These can actually be used on either side. I reached out to Lippert and they said to…

view full answer...

Answer 4

The correct replacement for a Power Gear Motor 1010001093 is the Replacement Motor for Lippert Power Gear Electric Leveling Jack System part #LC89CJ.

view full answer...

Answer 5

The replacement motor that you are needing is the Replacement Motor for Lippert Power Gear Electric Leveling Jack System - Right #LC89CJ (Lippert part number 386211) the 386211 is the correct replacement for the 1010001019 (right side). We also have…

view full answer...

Answer 6

The Replacement Motor for Lippert Power Gear Electric Leveling Jack System - Right #LC89CJ will be able to replace the right side motor.

view full answer...

Answer 7

The plug that includes the red wire from the Replacement Lippert Power Gear Manual Leveling Control Kit #LC359259 will plug into the back of the control panel and then the other end will plug into the connector coming off of the pump. The other…

view full answer...

Answer 8

It looks like we do have a replacement motor for the Power Gear 501473, it's the Replacement Motor for Lippert Power Gear Electric Leveling Jack System part #LC89CJ. Unfortunately, we don't offer a replacement for the actual leg as the system…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Replacement Motor for Lippert Power Gear Electric Leveling Jack System

Product Page this Question was Asked From

Continue Researching