Replacement Hanger Bolt For Toy Hauler Using Equa-Flex Suspension Equalizers
Published 11/02/2022 >
Products Featured in This Question
Question:
I broke the bolt where my toy hauler spring attaches to the hanger on the 3rd axlevery back. Is there a grade 8 bolt I can use? If so, what size? The springs are the Dexter 072-079-00 and the trailer is using the equaflex system.
asked by: Jeff K
Expert Reply:
The strongest Hanger Bolt # LC94UD we have is a grade 5 bolt. We do also have the Wet Bolt # LC126238 if your system was upgraded to these type bolts. These are not grade 5 as they have the hollow core for the grease to pass through. These are still capable of working on systems with up to 8,000lb axles. We do have the Nut # 006-092-01 which will fit either of these hanger bolts.
Product Page this Question was Asked From
Replacement Shoulder Bolt for Lippert Tandem Axle Lift Kit - 9/16" x 2-7/8" - Qty 1
- Accessories and Parts
- Trailer Suspension Parts
- Hardware
- Bolts
- Lippert
more information >
Continue Researching
- Q&A: Does 9610007991 Dometic Connect Essential RV Thermostat Have Furnace and Heat Pump Controls
- Q&A: Who Makes The Best Quality Trailer Bearings?
- Q&A: How to Reset Zero Point Calibration on Lippert Ground Control 3.0
- Q&A: What Information is Needed to Upgrade 5th Wheel Equalizers, Shackles, Wet Bolts, and Add X-Factor
- Q&A: Upgrading Leaf Springs on a Trailer with a 3500 Pound Axle
- Q&A: Replacement Leaf Spring Solution for 2021 Grand Design Solitude
- Q&A: Hub for E-Z Lube Spindle on Boat Trailer
- Article: Trailer Wiring Diagrams
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Brake Controller Installation: Starting from Scratch
- Article: How To Measure And Replace Everything In Your Hub Assembly

