Replacement Dust Cap/Bearing Buddy For a Hub With Bore Measurement of 47MM
Published 10/25/2022 >
Products Featured in This Question
Question:
Hi, I have a German boat trailer for my racing sailboat. I tried normal dust caps but they are a bit too large. The ID of the drum/hub is about 47mm. Do you have dust caps for this type of drum/hub? Regards
asked by: Bob T
Expert Reply:
The Bearing Buddy Bearing Protectors # BB1810 is the closest cap we have to your 47mm measurement. The Bearing Buddy fits a hub bore of 1.810" while 47mm is 1.850" so you will want to verify the exact measurement with a Caliper # PTW80157 to ensure if this will fit. The next largest size Bearing Buddy # BB1938SS fits a 1.938" hub bore. We currently do not have dust caps that match the measurements of the Bearing Buddy's I listed above.
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1810 - Chrome Plated - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.81 Inch
- 3500 lbs Axle
- Bearing Buddy
more information >
Continue Researching
- Q&A: Replacement Actuator for an Older Atwood 85736
- Q&A: Need a Grease Seal With Inner Diameter of 1.845 Inches and Outer Diameter of 2.442 Inches
- Q&A: Which Bearing Buddy Would Fit in Hub Bore that is 1-7/8 inches
- Q&A: Rubber Mat Needed for a 7 foot x 20 foot Gooseneck Featherlite Stock Trailer
- Q&A: Ribbed Rubber Mats for Floor of Horse Trailer
- Q&A: What Direction Should the Caliper Mounting Bracket Face on Kodiak Disc Brake Assembly, # K1HR35D
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Bearing Buddy Available for Hub Bore that Measures 1-7/8 inches
- Article: How to Measure for Trailer Hitch Drop
- Article: Most Popular Wheel Bearings
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Measure a Trailer Axle
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub

