What Tools are Needed for Installing Curt Hitch C12264
Published 10/21/2022
Question:
HI, Ahead of actual installation Ive been trying to ascertain what the socket size would be for the three through hitch to frame mounting bolts. So far Ive been told 10 and 12 mm but I dont believe that is correct, other than perhaps for the muffler hanger mounting bolts on the passenger side of the van. I believe these bolts may be 15mm and 18mm but would like to be certain. With the bolt closest to the rear bumper being #1 middle bolt #2 and front most bolt #3 what is the socket size for these bolts?
asked by: Dave
Expert Reply:
To install the Curt hitch part # C12264 that you referenced Curt states you will need the following tools:
3/8 inch ratchet
18 mm socket
15 mm socket
13 mm socket
torque wrench
screw driver/punch
utility knife
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- For Towing
- Class II
- 350 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What Part Of My 2016 Dodge Grand Caravan Do I Need To Trim? Can I Jack Up The Car By The Hitch?
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Recommended Trailer Hitch and Wiring for Towing a Popup Camper with a 2018 Dodge Grand Caravan
- Q&A: Can Atwood Carbon Monoxide Detector 33535 Replace 36681
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Replacement Microwave For Samsung MR1031UWC
- Q&A: How Do Self-Adjusting Brakes Adjust and Does it Work Going Forward or Reverse
- Q&A: Is Mounting Hardware Included With Curt Trailer Hitch For 2014 Chrysler Town And Country
- Article: Best Bike Racks for Electric Bikes
- Article: How to Attach a Cargo Carrier to a Roof Rack