Trailer Hitch Receiver and Wiring Harness For a Non-BlueTEC 2011 Mercedes-Benz ML350
Published 10/20/2022
Products Featured in This Question
Question:
Would this also fit ML350 models that is not BlueTec as well? Would this fit Both models?
asked by: Tony
Expert Reply:
For the non-BlueTEC 2011 Mercedes-Benz ML350 you will need the Curt Trailer Hitch Receiver # 13342. This has a different mounting bracket location than the Receiver # C13102 which fits the BlueTEC models.
The Vehicle Wiring Harness Kit # C59496 will allow you to add a 4-way flat wiring connector. This is the connector used on most smaller trailers you may tow. It will also allow you to use Auxiliary Lights # C53201 with any hitch mounted accessory that impairs the view of your vehicles tail lights.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Wire Gauge to Wire 8 Marker Lights and 2 Taillights on a Homemade Camper
- Q&A: Comparing Curt and etrailer.com Hitch for 2018 Nissan Pathfinder
- Q&A: How to Mount a 7-Way Connector on a 2017 Nissan Pathfinder with the Curt Hitch # C13309
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Hitch for 2010 Mercedes-Benz ML350 4matic
- Q&A: Available Replacement Door Latch to Fit an Wells Cargo Trailer
- Q&A: Parts Needed to Flat Tow 2021 Chevy Colorado Z71 4x4
- Q&A: Best Parts For Flat Towing a 2017 Chevrolet Colorado Z71 Behind a RV Motorhome
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups