Recommended Buyers Truck Mud Flaps for 24 Wide x 40 Tall Application
Updated 10/17/2022 | Published 10/16/2022
Products Featured in This Question
Question:
I need 24 x 26 inch Rubber Mud Flaps - if I cut the lower portion of 337B40LP up to the thickened horizontal band/section what would be the resultant height ?
asked by: Gerry G
Expert Reply:
Cutting the Truck Mud Flaps 24" Wide x 40" Tall # 337B40LP at that first horizontal band/section will give you a height of about 22" - 24". To save on how much extra material you'll have I recommend going with the Truck Mud Flaps 24" Wide x 30" # 337B30LP instead so you're just clipping off 4" from the bottom.
Depending on your setup you may need the 90-Degree Mounting Plates # 337MFBH2375A to finish your installation. Buyers also has the Bolt Hole Reinforcement Plates # 337MFW2375 to help make the connections more stable.
Attached are some videos for you to check out.
Product Page this Question was Asked From
Truck Mud Flaps - Black Rubber - 24" Wide x 40" Tall - Qty 2
- Mud Flaps
- Universal Fit
- Single
- 24 Inch Wide
- Rubber
- Buyers Products
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Which WFCO Replacement Converter to Allow Charging of Lithium Battery
- Q&A: Can The Blue Ox KarGard And Roadmaster Tow Defender Be used Together
- Q&A: What Is The Replacement Main Board Assembly For a WFCO WF-8900
- Q&A: Is the WF98FR Converter a Genuine WFCO Product and Does It Have the Up To Date Firmware?
- Q&A: Lithium Compatible Converter Replacement For WFCO WF-8955 55amp Converter
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Q&A: Recommended Lock for the Demco eZ-Latch Gooseneck Coupler Adapter
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups