Replacement Pitch Arm Assembly for Solera 63" Wall Mount Extrusion

Question

Question:

I need a Solera Awning Pitch Arm the wall mount extrusion measures 63” What pitch arm do I need?

asked by: Scott Y

0

Expert Reply:

It sounds like you're needing the Replacement Pitch Arm Assembly for Solera XL 63" Flat Awning Support Arm which comes in Black # LC67VR or White # LC62NJ depending on your application. These have an overall length of 33".

Attached is a review video for you to check out.

expert reply by: Jon G

0

Answer 1

You will need the Replacement Retaining Washer item #LC431583 to attach the gas strut on each of the pitch arm assemblies item #LC67VR or item #LC62NJ. So you will need one per gas strut.

view full answer...

Answer 2

I believe what you're looking for is the: -Replacement Pitch Arm Assembly for Solera XL 63" Flat Awning Support Arm #LC67VR. This arm measures 33" long, and is a direct replacement for the Solera XL 63" long flat awning support…

view full answer...

Answer 3

For the Replacement Retaining Washers for Solera Pitch Arm Assembly - Qty 1 Item #LC431583 you can just use a socket and press them on by hand. Lippert has an install video, which I'll be sending to you, that you can see them easily doing it by…

view full answer...

Answer 4

In order to find the correct replacement arms for your 2016 Shasta Oasis you're going to need to measure the overall length of current pitch arms. If that length is accurate, then you are going to need the, Replacement Pitch Arm for Solera Flat…

view full answer...

Answer 5

We have a replacement pitch arm for the #LC97UD with the part #LC62NJ but we do not have the portion that attaches to the RV wall.

view full answer...

Answer 6

Thanks for the photos, and from that it looks to me like you are asking if just the pitch arm assembly is available, and if so, the answer is yes, it is the Replacement Pitch Arm Assembly for Solera 69" Standard Flat Awning Support Arm…

view full answer...

Answer 7

When you go to install the Replacement Pitch Arm part #LC375994 you'd need to go with three of the retaining washers #LC431583.

view full answer...

Answer 8

When installing The Replacement Pitch Arm #LC375994 you will need to use three of the retaining washers #LC431583. I attached a review video link below.

view full answer...

Answer 9

Sorry to hear that! You will want to go over to the other side and measure the one that isn't broken. If the pitch arm is 33" then you'll need the Replacement Pitch Arm Assembly for Solera XL 63" Flat Awning Support Arm - Black…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Replacement Pitch Arm Assembly for Solera 63" Wall Mount Extrusion

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching