What are the Dimensions of the Wall Mounting Bracket for Stromberg Carlson Extend-A-Shower
Updated 11/14/2013 | Published 11/12/2013
Question:
What is the dimension of the mounting pad/plate that attaches to the wall?
asked by: Kurt
0
Expert Reply:
I went out to the warehouse and measured the wall mounting bracket on the Stromberg Carlson Extend-A-Shower, # EXT-3542. The overall height is approximately 3-5/8 inches and it is 1 inch wide. The holes are approximately 3 inches apart on center.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Stromberg Carlson Extend-A-Shower Shower Curtain Rod for RVs - 35" to 42" - White
- Accessories and Parts
- RV Showers and Tubs
- Indoor Shower
- Curtain Rods
- White
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Can a 50 Amp Watchdog Surge Protector Be Used on a 30 Amp Hookup?
- Article: Trailer Wiring Diagrams
- Article: Best Vehicles to Flat Tow Behind an RV
- Q&A: Replacement Breakaway Switch A UPG Model 42914 Breakaway Kit
- Q&A: Wiring Diagram for Kwikee Step Motor Conversion/Upgrade Kit # LC379145
- Q&A: Can 50 Amp Power Watchdog Surge Protector be Used with 30 Amp Power Source
- Q&A: Correct Replacement Pressure Switch for Lippert Level Up Hydraulic Leveling System
- Article: Ugly RV Makeover: How to Change Outdated RV Lighting
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Q&A: Should Wiper for RV Slide Out be Installed Upside Down
- Q&A: Correct Replacement Legs for Lippert Ground Control 3.0 Leveling System - 6 Point
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Top Gifts for Dads in 2024