What Tap Size to Use for Bolt Holes on the Curt Hitch # 13575
Published 06/30/2022
Question:
I have the Curt 13575 hitch and bolts but the frame holes are corroded and none of the bolts will thread. I used WD40 and a wire brush but no luck. The advice is to use a tap. What is the dimensions of the TAP?
asked by: Andre L
0
Expert Reply:
If you need to use a tap to tap out the threads for installing the Curt Trailer Hitch - 2" # 13575, you need to use a M8x1.25 and M12x1.25 tap. This are the sizes of the frame bolts used on the hitch. I went ahead and attached a helpful article and a screenshot of the parts list that shows the bolt sizes.
expert reply by:
Bob C
0
Parts List for Curt Trailer Hitch - 2" # 13575
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Trailer Hitch and Wiring Recommendation for a 2015 Mazda CX-9
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Q&A: Wiring Diagram for Bargman 7-Way RV Style Connector # WG54006-043
- Q&A: Towing Capacity of 2017 Toyota Sienna LE with Tow Package
- Q&A: J-Case Fuse Position For Curt 7-Way Harness On 2024 Honda Pilot Blocked
- Q&A: Trailer Hitch for 2017 Volvo XC90 R-Design and Mounting Bracket for Factory 7-Way Trailer Connector
- Q&A: Curt Hitch Recommendation for 2017 Volvo XC90