CE Smith Front Hanger Bracket # CE14016G Mounting Hole Dimensions
Updated 05/09/2022 | Published 05/08/2022
Question:
How far apart are the two mounting holes? What is the center to center distance for the bolts that connect to the trailer frame?
asked by: John W
0
Expert Reply:
The CE Smith Front Hanger Bracket # CE14016G 7/16" mounting holes are 3-3/8" on center.
expert reply by:
Bud M
0
CE Smith Front Hanger Bracket # CE14016G Mounting Hole Dimensions
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
CE Smith Front Hanger Bracket for Trailer Slipper Springs - Galvanized Steel - Bolt On - Qty 1
- Trailer Suspension Parts
- Hangers
- Boat Trailer
- Snowmobile Trailer
- Slipper Springs - 1-3/4 Inch
- 9/16 Inch Diameter
- 2-1/4 Inch Tall
- Single Axle
- Tandem Axle
- Triple Axle
- CE Smith
more information >
Continue Researching
- Q&A: How To Measure For Hub-Face And Spring Center Measurements On An Axle
- Q&A: Lightweight Trailer for Hobie Mirage Tandem Island
- Q&A: Leaf Spring Replacement for 21-1/2 Spring on 2001 StarCraft Camper
- Q&A: Choosing Replacement Fender for Tracker Marine Boat Trailer
- Q&A: Bolt On Slipper Springs for 1-3/4" Wide Slipper Springs on a Small Single Axle Trailer
- Q&A: Replacing the Drop Leg Spring Loaded Pull Pin on a Bulldog 180 Series Square Jack
- Q&A: Replacement Gear Kit Instructions and Diagram for Ram 12,000 Series
- Article: Trailer Wiring Diagrams
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Double-Eye Trailer Suspension System Review
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Raise Your Travel Trailer Height
- Article: Where to Position the Trailer Axle?