What are the Dimensions of Chrome Trailer Hitch Receiver Tube Cover, # F-10P
Updated 09/10/2013 | Published 09/09/2013
Question:
I would like to know the dimensions of the 2 Blank/Chrome trailer hitch?
asked by: Brett
0
Expert Reply:
I went out to the warehouse and pulled the Chrome Trailer Hitch Receiver Tube Cover, # F-10P, to take some measurements. The width at the widest point is 5-3/8 inches and at the narrowest point 2-3/4 inches. The height is 3-1/8 inches. The center of the hitch pin hole to the back of the cover is 2-1/4 inches. The overall depth is 3-1/2 inches.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Chrome Trailer Hitch Receiver Metal Tube Cover - 2"
- Hitch Covers
- Misc Covers
- Plain
- Metal Face
- Fits 2 Inch Hitch
- Standard
- Square
- CURT
more information >
Continue Researching
- Q&A: Replacement Wheel Stud for 1990's Ranger Boat Trailer
- Q&A: Can the Center Knockout Panel be Re-Installed After a Trailer Hitch on a 2015 Cadillac SRX
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Size of Ball Shank Hole on Weigh Safe Hitch w/ Built-In Scale for 2" Hitch
- Q&A: Replacement Wheels for Ranger Boat Trailer With 14" x 5-1/2" Rims
- Q&A: Recommended Replacement for a Marshall 290-1 Regulator
- Q&A: Recommended Hitch Ball That Works With A 1-3/8 Diameter Shank And Has A 30,000-lb Capacity
- Q&A: Does Receiver on Trailer Hitch DT65MR Stick Out Past Rear Bumper on a 2014 Toyota Highlander
- Article: Trailer Hitch Installation Tips