What Size Hardware Is Needed To Mount The Dutton-Lainson Wiring Harness for StrongArm Electric Winch
Updated 03/09/2022 | Published 03/08/2022
Question:
What do you use to mount the connector to your vehicle? I would prefer not to have the wiring from the battery coiled up in the open bed of my truck.
asked by: ED
0
Expert Reply:
The Dutton-Lainson Wiring Harness for StrongArm Electric Winch # DL24152 can be mounted to your vehicle with 1/8" bolts or screws through the holes in the connector. The type of hardware and any mounting bracket needed will depend on where you decide to mount the connector on your 2018 Ford F-150.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Dutton-Lainson Wiring Harness for StrongArm Electric Winch Model TW4000 Manufactured after 2014
- Accessories and Parts
- Electric Winch
- Wiring
- Wiring Harness
- Dutton-Lainson
more information >
Continue Researching
- Q&A: Replacement Winch Recommendation for Trailer with 4,000 lb Boat
- Q&A: Selecting Electric Boat Trailer Winch with Manual Operation Capability
- Q&A: Higher Capacity Replacement For Shelby 5407 Hand Winch
- Q&A: Troubleshooting External Sensor Error on Lippert Leveling System
- Q&A: Is Bulldog Winch Controller 20125B Water Resistant and Double Pole Reversing
- Article: How to Wire an Electric Winch
- Q&A: Recommended Replacement for Atwood GC10A-4E RV Water Heater
- Q&A: Is There an Extra Wiring Harness Available for the Dutton-Lainson TW4015?