Replacement Dust Cap for Hub of Malone LowMax Trailer

Question

Question:

I need hub dust caps for my low max trailer. Which product do I need? Thanks,

asked by: Adam W

1

Helpful Expert Reply:

For the Malone LowMax trailer the correct replacement dust cap is the part # F001518.

expert reply by: Jameson C

1

Answer 1

No, it is not normal for seals to go bad that quickly. Typically if your hubs are spraying/leaking grease, it is because of a bad seal. From what I could find, it looks like your Malone Microsport trailer has a 1.98 inch diameter hub. The correct…

view full answer...

Answer 2

The Malone MicroSportXT Trailer part #MPG460XT will stand roughly 8' 2" tall or 98" tall with the tongue retracted and stood up for storage.

view full answer...

Answer 3

Hello Chris. The Grease Cap #F001518 will indeed be a suitable replacement for the Malone MicroSport trailer. The MicroSport uses a standard 5 on 4-1/2" hub and these hubs use the also standard 1.98" grease caps. The #F001518 cap is not…

view full answer...

Answer 4

The Malone MicroSport trailers like you have use the bearing kit part #BK1-100 that you mentioned which comes with the correct seal size. Or for a replacement hub that comes pre-greased part #34822545BX. Then for a heavy duty and waterproof grease…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Replacement Dust Cap for Hub of Malone LowMax Trailer

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching