Is Clunky Feeling After Installing Trailer Jack Gear Set Normal
Published 02/15/2022
Question:
Just bought replacement gears for my Fulton F2 1600 trailer jack, and it seems to chunk a little while lifting or lowering under pressure. Everything looks right, but could a bent handle cause this? I cant seem to see anything else that is amiss. Thanks!
asked by: Mark A
0
Expert Reply:
It is most likely that the gears are so new they just aren't meshing as perfectly as you'd like. The more you use the jack they more the problem will go away as the clearances will become smoother basically.
expert reply by:
Jameson C
0
Continue Researching
- Search Results: fulton f2 parts
- Q&A: Replacement Gear Kit For Fulton F2 Trailer Jack
- Q&A: Replacement Gear Recommendation for Fulton Trailer Jack
- Q&A: Replacement Gears For A Fulton F2 Trailer Jack
- Q&A: What Is The Thickness Of The Replacement Gear Kit For Etrailer And Ram Sidewind Jacks
- Q&A: Is a Replacement Gear Housing Available for the Fulton F2 Swing-Up, Wide-Track Trailer Jack?
- Q&A: How To Install the Landing Gear Set Part # RVLG-8000
- Q&A: Comparing Curt Trailer Winch C45ZJ And Fulton F2 Fully Enclosed Winch FW32000101
- Article: 7 Steps to Clean Your RV Awning, Prevent Mold, and Save Money