Do All UWS Toolboxes Come with the Same Key

Question

Question:

I notice that lots of tool boxes use the CH501 key. That key will unlock just about every RV storage compartment built in the last 30 years. How can these boxes be secure with so many CH501 keys floating around?

asked by: Rhio H

0

Expert Reply:

Not all UWS tool boxes use the same key actually. We sell replacement keys for the UWS toolboxes and they range pretty widely so you the key you'd get with the part # UWS01061 would most likely not come with the same key you mentioned.

expert reply by: Jameson C

0

Answer 1

Thanks for reaching out, Zhen! The Yakima 54" Tracks for Roof Racks #Y26RR has smaller tracks designed for use with a roof rack mounting system, while the Yakima 54" HD Tracks for Roof Racks, OverHaul HD, and OutPost HD #Y64MR are a bit…

view full answer...

Answer 2

I went out to our warehouse and tested the UWS Rod-Connector #UWSRODCONNECTOR with the Replacement Locking Latch for DeeZee Tool Boxes - Hook Style #DZTBLATCH1 to confirm they will work together.

view full answer...

Answer 3

The Yakima JetStream crossbars have a T-slot that is 1 inch wide and 1/2 inch tall so any t-bolt used would have to fit within those measurements. The 4-bolt set of M10 x 1.5 x 25 bolts #Y8880184 will work since the head is 3/4 inches square but I…

view full answer...

Answer 4

The T-slot channel dimensions for the Yakima HD Crossbars #Y01158 are 11mm (7/16") wide on top, 8mm(5/16") deep, and 22mm(14/16") wide at it's bottom. I attached a picture of the HD crossbar's diagram as well as a video with…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Do All UWS Toolboxes Come with the Same Key

Product Page this Question was Asked From

Continue Researching