Setting Distance Between Front and Rear Hangers of Trailer Suspension
Published 12/30/2021
Question:
I have 2 new 7k axles and center of spring holes is 25inch my equalizer is 6inch center of holes, do I simply add half of my equalizer and space my hangers at 28 so an equal load would have the shackle straps sitting perpendicular to the trailer deck?
asked by: Robert
0
Expert Reply:
You will want the equalizer to angle in about 1/2 an inch so you'd need to compensate that by taking one inch off of the distance you mentioned so 27 inched would be correct distance between the hanger bolt centers.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
- Trailer Suspension Parts
- Shackle Links
- Camper
- Car Hauler
- Utility Trailer
- 2-3/4 Inch Long
- TruRyde
more information >
Continue Researching
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Which MORryde Shackle To Go With When Replacing 2-3/4" Shackles On A Forest River Travel Trailer
- Q&A: Limited Tire Clearance with Stock Tire Size on a 2006 Forest River Cherokee 27Q
- Q&A: Hub and Drum Assembly for AL-KO T-52 Axle
- Q&A: What Would Cause Trailer Equalizer to be Tilted to One Side After Install of New Leaf Springs
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: Double-Eye Trailer Suspension System Review
- Q&A: What is the Strength Rating for the Weigh Safe and B&W Locking Hitch Pins?
- Q&A: Can Longer Trailer Suspension Equalizer be Replaced with Shorter One
- Q&A: Looking To Replace My Attwood Master Cylinder 85736
- Article: Trailer Wiring Diagrams
- Article: How to Raise Your Travel Trailer Height
- Article: Most Popular Wheel Bearings
- Article: How to Tell the Weight Rating of a Trailer Axle