Will the Lock N Roll Articulating Coupler Fit a Karvana Trailer
Published 12/14/2021
Products Featured in This Question
Question:
Hello was just trying to see if you could possibly verify if part#336TS504, weld-on A-frame would fit on a 5x8 karavan utility trailer. I do have pictures with measurements off the trailer if need be that I could send, thank you.
asked by: Daniel P
Expert Reply:
The Lock N Roll Articulating Coupler part # 336TS504 fits a standard 50 degree a-frame so it's a go for a Karvana trailer. You'll need to grind off or unbolt the old coupler then weld the new one on, easy work for any decent welder. If you need the vehicle side I recommend the Lock N Roll Articulating Hitch w/ 3-Position Channel part # 336VS503505.
Product Page this Question was Asked From
Lock N Roll Articulating Coupler - A-Frame - Trailer Side - 11K
- A-Frame Trailer Coupler
- Off Road Coupler
- 50-Degree Frame
- Weld-On
- 11000 lbs GTW
- Latch Plates
- 2-5/16 Inch Hole
- Standard Grade
- Lock N Roll
more information >
Continue Researching
- Q&A: Correct Timbren Axle-Less Trailer Suspension System for 2018 Scamp 13 Trailer
- Q&A: How to Install Brake Controller on 2020 Jeep Wrangler Unlimited without Factory Tow Package
- Q&A: Trailer Coupler Solution for a 30 Degree Trailer Frame
- Article: Installing an Electric Brake Controller on a 2013 Dodge Ram
- Q&A: Installing Brake Controller in 2014 Ram 2500 in Place of Factory Brake Controller
- Q&A: Is There a Trailer Coupler Designed For Offroading
- Q&A: Is There Lock N Roll Articulating Hitch that Fits 2 inch Hitch
- Q&A: Looking For RV Range To Replace Dometic R2131-BBPFBO
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Lighting Requirements
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride
- Article: Hitch Anti-Rattle Devices: The Ultimate Guide
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: How to Measure Your Trailer Wheel Bolt Pattern