Can The Command Electronics LED Light 328-ET003184CWM Be Hooked Up To A Dimmer Switch?

Published 11/30/2021

Products Featured in This Question

LED Bullet Utility Light with Grommet - Recessed Mount - 1 Diode - Clear Lens

(26)

$7.61

Chrome Trim Ring for Command Electronics LED Bullet Clearance or Side Marker Light

$1.95

Question:

I would like to use these 1inch 3/4inch lens LEDs as ceiling lights in a doll house that is 1/6th scale. Is it dimmable if connected to a dimmer switch, or does it come in a warm white light? Also, it appears that the back end closer to wire unscrews to sandwich the fixture between the surface it is being used on - is that correct? Thank you.

asked by: Elwyn F

Expert Reply:

I spoke to Command Electronics and the LED Bullet Utility Light with Grommet # 328-ET003184CWM can indeed be hooked to a dimmer switch without issue. However, said dimmer switch does need to be rated for use with LED lights as not all of them are

Though the grommet can be removed, the light will not come apart. With the grommet attached, it will snap into a 3/4" hole. A potential add on to go along with this is the Chrome Trim Ring # 328-89-387. It would give them a nice clean look once installed and hooked up.

expert reply by: Lazer S