Is the CIPA Rearview Boat Mirror CIP54FR Suction Cup Mounted

Question

Question:

In the description, it says suction mount, but the video says you need to buy separate clamp mount.

asked by: Marianne J

0

Expert Reply:

The CIPA Rearview Boat Mirror part # CIP54FR will require the CIPA Mirror Bracket for Boat Windshield part # CM02310 for installation. If you're looking for a suction cup mounted mirror then I recommend the CIPA Rearview Boat Mirror part # CM11050.

expert reply by: Conner L

0

Answer 1

The clamp-on boat rearview mirrors we offer like the #CM11080 you'd looked at will all need a minimum windshield thickness of at least 3/8 of an inch in order to attach securely. If your boat windshield is thinner than that, a suction cup mirror…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Is the CIPA Rearview Boat Mirror CIP54FR Suction Cup Mounted

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching