Connecting Harley Davidson 5 wire Harness to a 4 Flat Connector on a Trailer

Updated 06/17/2013 | Published 06/15/2013

Products Featured in This Question

Hopkins Wiring Harness with 5-Pole Flat Trailer Connector - Vehicle End - 5' Long

(15)

$12.66

Hopkins Tail Light Converter with 4-Way Flat Trailer Connector

(48)

$30.47

Hook Probe Circuit Tester

(60)

$13.33

Question:

I am trying to connect my 5 wire Harley wiring harness to my trailer that uses a 4 flat set up. The harness on the bike has a plug and play harness with direct connect to battery power and ground. Thank you in advance

asked by: Pat C

Expert Reply:

I would recommend you cut off the 5-way on your motorcycle. Wire in a tail light converter kit part # HM48895. This will convert your separate circuit tail light signal of your motorcycle to a combined circuit like what your trailer has.

On Harleys the turn signal wire circuit is separate from the brake light circuit so a converter like the # HM48895 is needed to convert the signal into a combined circuit like what your trailer has.

You will need a circuit tester like our part # PTW2993 to determine the functions of the connector on your motorcycle and then need to wire it by function to the circuits of the # HM48995.

I attached an FAQ on trailer wiring for you to check out also.

expert reply by: Jameson C