Replacement 2 inch Square Jack Drop Leg that is 18 inches Tall
Published 11/04/2021
Question:
I am looking for a replacement Jack leg 2 inch square with a minimum rating of 6000 pounds and minimum height of 13 inches. The holes in the jack are about 0.6 of an inch, but they arent all the exact same size. A 9/16th inch pin should work. What would you recommend?
asked by: Michael S
Helpful Expert Reply:
The part # BD500270 would be the closest drop leg we offer to what you are looking for as it is 2 inch square, has a capacity of 8,000 lbs, and a height of 18 inches. The holes are 5/8 inch which is .625 in decimal form.
Product Page this Question was Asked From
Replacement Drop Leg for Bulldog Square Trailer Jacks - 18" - 8,000 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Drop Leg
- 2 Inch x 2 Inch Tubing
- Bulldog
more information >
Continue Researching
- Search Results: replacement drop leg
- Shop: Replacement Drop Leg for Bulldog Square Trailer Jacks - 18" - 8,000 lbs
- Shop: Replacement Drop Leg with Foot for etrailer and Ram Square, Direct Weld Jacks - 7,000 lbs
- Q&A: Recommended Stabilizer Supports For Equipment Trailer That Lifts Back Of Truck Off The Ground
- Q&A: Looking to Install the etrailer Hitch e98912 on My 2025 Subaru Crosstrek, Can I Use Smaller Hardware
- Q&A: How to Position the Lippert Shocks on a Single Axle Trailer
- Article: Big Truck Big RV
- Q&A: Factory Location for Brake Controller Wiring Harness Install on 1996 Ford F-250 or F-350 Models
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Square Drop Leg Stabilizer Jack Tube and Pin Hole Diameters
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: What is the Correct Hub Replacement for Dexter 8-208?
- Q&A: Replacement Coupler for Dico 17550 Weld-On Coupler
- Article: Trailer Jacks
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Lighting Requirements
- Article: Rooftop Cargo Carriers