Will the Demco UMS Series Gooseneck Hitch Fit a 2015 Silverado 2500 Short-Bed?
Published 09/28/2021
Products Featured in This Question
Question:
I do have the demco ums rails my concern is the turning radius dont want to hit the cab. will it still be at least 90+ degrees or will I have to have some kind of an extension ball to move the center point back.
asked by: Bob B
0
Expert Reply:
As long as the rails you currently have installed on your 2015 Silverado 2500 short bed are the UMS style rails, like the Demco # DM8551010, you can definitely use the Demco Hijacker UMS Series Gooseneck Trailer Hitch # DM5988.
If you have another brand of auto slider and or rails, however, I cannot guaranty the fit.
expert reply by:
Lazer S
0
Product Page this Question was Asked From
Demco UMS Series Gooseneck Trailer Hitch for UMS Series Base Rails - 25,000 lbs
- Gooseneck Hitch
- Gooseneck for 5th Wheel Rails
- Fixed Ball
- 6250 lbs TW
- 25000 lbs GTW
- Demco
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Gooseneck Hitch for a 2026 Chevy 2500 HD without OEM Prep Package
- Q&A: What is Width Dimensions of Atlas IV Hydraulic Trailer Jack # ST23FR
- Q&A: Does Demco Underbed Kit Give Full Bed Access for 2021 Chevy Silverado 2500
- Q&A: 2025 GMC Sierra 2500 5th Wheel Hitch Recommendation for OEM Puck System and 6-1/2' Bed
- Q&A: Distance from Top of Ball to Bottom of Plate on Demco Gooseneck Hitch for 5th Wheel Rails DM5996
- Q&A: How to Tell if 2018 Ford F-250 Has Puck System to use Demco Hijacker Autoslide
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Estimated Install Time For B&W Turnoverball Gooseneck Hitch BWGNRK1020
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Cargo Tie-Down Methods
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
Bob B.
9/28/2021
I do have the demco ums rails my concern is the turning radius dont want to hit the cab. will it still be at least 90+ degrees or will I have to have some kind of an extension ball to move the center point back.