What Gauge Wires Does the Replacement Wiring Harness for Lippert Slide-Out Controller Use
Updated 09/20/2021 | Published 09/19/2021
Question:
What gauge is the wire used for this item and what amps does it draw as well.
asked by: Alvin S
1
Helpful Expert Reply:
I spoke with Lippert about the Replacement Wiring Harness for Lippert Slide-Out Controller part # LC135696 and they informed me that the wire gauge for the black and red wires is 10 and 16 for the yellow and green. The amp draw would be determined by the motor, not something I can provide for this harness.
expert reply by:
Conner L
1
Product Page this Question was Asked From
Replacement Wiring Harness for Lippert Slide-Out Controller
- RV Slide Out Parts
- Controller Parts
- Wiring Harness
- Lippert Slide-Out Systems
- Lippert
more information >
Continue Researching
- Shop: Replacement Wiring Harness for Lippert Slide-Out Controller
- Q&A: Troubleshooting Dual Motor Slide Out Malfunctions
- Q&A: Replacement Slide Controller For 13398-C Dual Motor Synchronous Velocity Slide Controller
- Q&A: Which Side Is The Fixed and Floating For the Lippert RV In-Wall Slide-Outs?
- Q&A: Fixed Side Vs. Float Side for Replacement Standard Dual Rack Repair Kit Wall Slide-Out
- Q&A: Replacement Slide Motor for Schwintek System
- Q&A: Replacement For High Pointe Built-In Convection Microwave with Air Fryer ECO28KD7
- Q&A: Replacement RV Microwave Recommendation for High Pointe EC028BMR
- Article: How to Set the Right PSI for Your Air Bags
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Wiring Diagrams
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: How to Install a Weight Distribution Hitch (With Pictures & Video)
- Article: Flat Towing Package for 2015-2018 Ford F-150