Connecting Diamond LED Trailer Tail Light to RV With Two Wires
Updated 09/13/2021 | Published 09/12/2021
Question:
Hi. Our RV has same size tail light. But only two wires. How do I connect this light with three wires to only two wires coming out of my trailer?
asked by: Mike
Expert Reply:
The third wire on the back of the LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 52 Diode - Oval - Red Lens # DG52448PB is the ground wire. You will want to connect the black power wire, which is for the tail or running lights, and the red wire, which is for the stop and turn signals, to the two wires on your RV. The white wire, which is the ground wire, needs to be connected to a clean, bare-metal surface.
Product Page this Question was Asked From
Low Profile LED RV Light w/ Reflector - Brake, Tail, Turn - Submersible - Oval - Red
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Oval
- Surface Mount
- Submersible Lights
- LED Light
- 8-3/8L x 5-3/4W Inch
- Red
- Diamond
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Possible Replacement Solution for Reflect-O-Lite 1400
- Q&A: Recommended Replacement LED Back-Up Light
- Q&A: Replacement Ladder for 2017 Grand Design Solitude
- Q&A: Replacement Power Converter For Lithium Batteries For a PD4590 Power Converter System
- Article: Installing Electric Brake Controls on a 2010-up Dodge Ram
- Q&A: 2018 Ram 2500 Diesel Brake Controller Installation
- Q&A: Recommended Replacement A Jensen VM9726BT RV Stereo
- Q&A: No Signal on Furrion Vision S Wireless RV Backup Camera System
- Article: Trailer Wiring Diagrams
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers