Does Bumper Fascia Need to Get Trimmed to Install Curt # C11333
Published 08/31/2021
Question:
Replacement bumper guide is in one piece across where you cut plastic fascia. Do I need to cut it??
asked by: Kip S
0
Expert Reply:
You do need to trim the rear fascia to install the Curt hitch part # C11333. Here's the description on what gets trimmed:
Measure to find the center of the fascia, mark the area to be trimmed. Trim center of bumper fascia as shown approximately 2 1/4" wide by 4 1/2" long. Carefully trim fascia.
You can see a picture of this in the attached instructions.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: My Trailer Hitch Doesn't Fit
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Will Yakima FullBack Bike Rack Work Well On 2013 Mini Countryman
- Q&A: Platform or Hanging Bike Rack Comparison and Recommendation
- Q&A: Why Do Hitch Extenders Reduce Hitch Capacity but Long Ball Mounts Do Not
- Q&A: Questions About Trailer Hitch For 2014 Mini Countryman
- Q&A: Does Flat Towing Setup Create Tongue Weight on Vehicle Hitch
- Q&A: Estimate of How Long it Takes to Install Trailer Hitch and Wiring on 2017 Ford Transit T250
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Best Bike Racks for Electric Bikes