Valterra Bladex Waste Valve Body for RV Gray Water Tank Thickness
Updated 08/16/2021 | Published 08/14/2021
Question:
The original Valterrra assembly has an identifier on it ABS 1015 and the black and gray water both connect to it. I need to replace the seals on both black and gray. You still have seals for the black 3 but do not have seals for the 1 1/2 gray. I was wondering if I could replace the current housings with the newer Bladex style? The 3inch assembly is about 7/8inch thick and the 1 1/2 is 3/4 thick. I dont see dimensions for the Bladex style to determine if this would be an option?
asked by: William G
Expert Reply:
The Valterra Bladex Waste Valve Body for RV Gray Water Tank - Plastic Handle - 1-1/2" Diameter # T1001VP is 5/8" thick.
Product Page this Question was Asked From
Valterra Bladex Waste Valve Body for RV Gray Water Tank - Plastic Handle - 1-1/2" Diameter
- RV Waste Valve
- Straight Valve
- Single Waste Valve
- 1-1/2 Inch Valve Body
- Manual
- 1-1/2 Inch Spigot
- Stationary Valve
- Valterra
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended SnapPad Jack Pads for a HWH Leveling System on a Motorhome
- Q&A: Recommended Class IV Hitch for a 2012 Chevrolet Silverado 1500
- Q&A: Can I Use the etrailer Awning Fabric on a Solera Awning
- Q&A: How Do I Adapt a 1-1/2" Gray Water Valve to a 3" Bayonet Sewer Connection?
- Q&A: Replacement Grease Cap Plug for EZ Lube Grease Cap
- Q&A: Recommended LCD Single Zone Thermostat for Dometic RV Air Conditioners
- Q&A: Replacement Roof Vent Lid for Dexter Roof Vent Serial Number VE0108
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Does Solar Panel Type Really Matter?
- Article: Converting Your RV Water Heater to Tankless
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How Much Solar Power Do I Need For My RV?